4700 groundmaster roller seal puller Cancel The title field is required!

1. David Brudwick

   

   1 posts
   
   1/23/2015 9:01 PM

   Hi everyone, I have some bad bearings in my rear rollers. Problem is I can't get the grease seal out. My seal puller can't reach it. Does toro make a puller for the 4700?? What are my options.... Thanks for your time....

   
   
   
   
2. Roland McPhearson

   

   9 posts
   
   1/24/2015 12:01 PM

   The part # of the roller and seal will be helpful since there were 3 different rollers made by Toro. I'm guessing you're referring to the inner seal of the 2nd or 3rd Gen. If so I usually use a "cat's paw" or "ladyfoot" http://www.amazon.com/Mayhew-Tools-6015 ... B0000T4UO8 shown at the 5:50 mark of the following video.
   https://www.youtube.com/watch?v=DyDF4WMXVZo

   
   
   
   
3. David Brudwick

   

   1 posts
   
   1/24/2015 4:01 PM

   Thank you, That's what I was looking for. I have a 2006 4700 , roller part number 107-1996 seal # 93-3007. Thanks for the information!!!!!

   
   
   
   
4. Roland McPhearson

   

   9 posts
   
   1/24/2015 6:01 PM

   That's the 2nd Gen roller that you have. In addition to the cat's paw I've also used the puller shown at 0:33 of the following video (though this video is showing a different application for the puller). https://www.youtube.com/watch?v=ZBzVd-b5ZYE
   
   Regarding those 2nd Gen rollers, I've used 2 different methods for rebuilding them. You may pick up some tips in these videos even if you don't have a Tamer.
   
   https://www.youtube.com/watch?v=DyDF4WMXVZo (already posted this video in my previous reply)
   
   https://www.youtube.com/watch?v=b094INIjwoQ

   
   
   
   
5. David Brudwick

   

   1 posts
   
   1/31/2015 9:01 PM

   Thanks Roland appreciate your help !!!!!