John Deere 7500 E Cut issue Cancel The title field is required!

1. Nicholas Daak

   

   3 posts
   
   5/27/2020 11:05 AM

   Reels do not turn on at all.  PTO switch has been switched, voltage is fine to reel modules, and raise lower switch/lever works.  Any help will be appreciated.

   
   
   
   
2. Ed Ward

   

   20 posts
   
   5/29/2020 12:05 AM in reply to Nicholas Daak

   There should be another switch that tells the computer  the reels are down the wiring diagram should tell you if there is one.

   
   
   
   
3. Blake Helland

   

   1 posts
   
   5/29/2020 7:05 AM

   There are two proximity sensors one on the right and left front lift arms. You can access the connections from under the front fenders right behind the motor controllers (its tight). You will see the proximity sensor just below the the controllers behind the front tires. I would check for wiring issues or bad sensor. I had one unplugged during repairs and it prevented all of the reels from turning.