replacing bearings and seals on GKIV rear rollers Cancel The title field is required!

1. Johnson Aaron M

   
   1/21/2015 11:01 AM

   Having a heck of a time getting the roller shaft out of the roller tube so I can replace the leaking seals and bad bearings on our GKIV Plus rear rollers. Besides a roller tamer, how is everyone knocking these out to get to the bearings and seals?

   
   
   
   
2. Roland McPhearson

   

   9 posts
   
   1/22/2015 4:01 PM

   What's the part # of the roller?
   
   If it has the 3010210 seal in each end it looks like you'll need to remove one of those seals first.

   
   
   
   
3. Ryan Green

   

   2 posts
   
   3/27/2015 8:03 PM

   get a seal puller to pry out the seals. there is no nut holding the bearings in. just pound the end of the shaft on a hard surface and the bearing and shaft will come right out