Buffalo Blower? Cancel The title field is required!

1. Ryan Bruner

   

   4 posts
   
   9/23/2014 9:09 AM

   Having a problem with my blower. When I try to use remote to power up or turn nozzle nothing happens. I have replaced batteries and check connections. Any suggestions?
   
   Thanks.

   
   
   
   
2. Keith Lamb

   

   3 posts
   
   9/23/2014 10:09 AM

   Either blown fuse or if you have the wireless remote, have tried to jump start lately and didn't unplug remote control box you may have fried remote control box.

   
   
   
   
3. Henry Heinz

   

   0 posts
   
   9/23/2014 2:09 PM

   The remotes lose their programing from time to time, more so when operating close to another blower with remote. Try reprogramming it. Turn key to on position, then hold/press the throttle increase+ and ccw and throttle decrease- for at least 3 seconds simultaneously. You should see the shoot start to turn then you know the programming took place. This happens to us often as we run 8 of these units. Also make sure the fuse is tight in its connector, I have had issues there too and will do the same thing, but 9 out of 10 times it's the remote needing programmed.
   
   Regards,