WORKMAN 200 SPRAYER, FOAM MARKER DIAGNOSTICS Cancel The title field is required!

1. Dave Depp

   

   3 posts
   
   4/13/2017 7:04 AM

   I have a workman 200 sprayer that the foam marker does not work on. Pump runs, blows air, not much pressure about like an air pump on a fish tank. Blowing air into tank, nothing coming out of tank. Any pressure specs or diagnostic info would be greatly appreciated. Thanks for this forum.
   Dave Depp

   
   
   
   
2. Mike Hundley

   

   0 posts
   
   4/18/2017 5:04 PM

   Make sure seals are good. Otherwise, I suppose you are priming it?

   
   
   
   
3. Bob Pruneau

   

   5 posts
   
   4/23/2017 10:04 AM

   Not sure if it's the same type as the 1250 . I fought this issue for a long while . The water we used from pond had high salt content and corroded around the reed valve keeping it from pumping pressure . Replaced parts and they only used Clean bottle water or city water from then on it was great .