workman 3200 fuel pump Cancel The title field is required!

1. Kevin Fateley

   

   5 posts
   
   5/18/2017 11:05 AM

   Looking for a equivalent fuel pump that does not cost $375! any suggestions?
   This is for the Mitsubishi unit. I did find a carburetor kit for the U42T carb. It was $275.
   
   Thanks

   
   
   
   
2. Roland McPhearson

   

   9 posts
   
   5/18/2017 12:05 PM

   Is the toro number 92-2007? if so, a Napa E8090 (P74019) should replace it.

   
   
   
   
3. Kevin Fateley

   

   5 posts
   
   5/18/2017 1:05 PM

   Yes that is the number and thank you!

   
   
   
   
4. Melvin Waldron

   

   43 posts
   
   5/18/2017 2:05 PM

   When information like that is shared, it sure goes to show the value of membership, heck a couple helps like that would pay membership dues for the year. That doesn't count all the other info and education we get, (along with the association advocating on our behalf) Oh yea, and that magazine.
   
   Thanks for sharing Roland.
   
   Mel

   
   Melvin H. Waldron III, CGCS, Horton Smith Golf Course, City of Springfield/Greene County MO
   
   
5. Roland McPhearson

   

   9 posts
   
   5/19/2017 9:05 AM

   Gift cards for Popeye's Fried Chicken mailed to
   
   23 Academy Ct
   Bedminster NJ 07921
   
   will not go unused.

   
   
   
   
6. Kevin Fateley

   

   5 posts
   
   5/19/2017 10:05 AM

   Roland,
   A question. Our motor is the Mitsubishi 3 cylinder and that pump has 3 wires going to it. Which is weird one goes back to the carburetor and some how turns flow off as needed? That Napa pump has 2 wires. My question did you bypass the third wire somehow or did you think we just needed a fuel sender with 2 wires (like we did)?
   
   And Mel you are right the Forum is my GCSAA value!
   
   Thanks

   
   
   
   
7. Roland McPhearson

   

   9 posts
   
   5/22/2017 3:05 PM

   I don't have one. I was passing along second hand info which I believed to be accurate but obviously was not. What is the model and serial of yours? I will try to look at the diagram.

   
   
   
   
8. Anthony Lewis

   

   1 posts
   
   5/23/2017 6:05 AM

   Kevin Fateley said: Roland,
   A question. Our motor is the Mitsubishi 3 cylinder and that pump has 3 wires going to it. Which is weird one goes back to the carburetor and some how turns flow off as needed? That Napa pump has 2 wires. My question did you bypass the third wire somehow or did you think we just needed a fuel sender with 2 wires (like we did)?
   
   And Mel you are right the Forum is my GCSAA value!
   
   Thanks

   
   
   Hey Kevin our Mitsubushi 3 cylinder 3200 has a napa pump on it too. I have the blue wire snipped at the connector and only used the red and black to power the aftermarket pump. I did this 6 years ago with no issues and can't remember exactly how the schematics were but this worked.